Defrosting; Stopping Your Product - Teka TKI2 145 D Manual De Instrucciones

In case of a temporary ice build
5
up in the fridge compartment
reduce the thermostat setting
to 1, monitoring at the same
time that the fridge temperature
is maximum +5 degrees C
4
(41 degrees F). Once the ice
build up disappears and the
appliance starts auto defrosting
3
again as normal, then you
may increase the thermostat
setting, if required.
2
1
0

Stopping your product

If your thermostat is equipped with
"0" position:
- Your product will stop operating
when you turn the thermostat button to
"0" (zero) position. Your product will not
start unless to you turn the thermostat
button to position "1" or one of the
other positions again.
If your thermostat is equipped with
"min" position:
- Unplug your product to stop it.

DEFROSTING

The larder fridge defrosts automatically.
The defrosting water runs to the drain
tube via a collection channel and is
evaporated in a special container (1) at
the back of the appliance (see diagram).
During defrosting
may format the back of the larder
fridge where concealed evaporator is
located. Some droplets may remain on
the liner and refreeze when defrosting
is completed. Do not use pointed or
sharp edged objects such as knives,
forks to remove the droplets which
have refrozen.
If at any time the defrost water does
not drain from the collection channel,
check to ensure that no food particles
have blocked the drain tube. The drain
tube can be cleared by pushing the
special plastic plunger provided down
the drain tube (2).
Special Container
15
EN
water droplets
2
1
Compressor