General Information; General Description Of The Machine - Sima DAKAR MK45 Manual De Instrucciones

1. GENERAL INFORMATION

WARNING: Please read and understand perfectly the present instruction before using the machine.
SIMA S.A. thanks you for your trust in our products and for purchasing the TABLE SAW DAKAR MK45 model
This manual provides you with the necessary instructions to start, use, maintain and in your case, repair of
the present machine. All aspects as far as the safety and health of the users is concerned have been stated.
Respecting all instructions and recommendations assures safety and low maintenance. As such, reading this manual
carefully is compulsory for any person responsible for the use, maintenance or repair of this machine.
As such, reading this manual carefully is compulsory for any person responsible for the use, maintenance or
repair of this machine.
It is recommended to have always this manual in an easily accessible place where the machine is being
used.

2. GENERAL DESCRIPTION OF THE MACHINE

Cutting Table Saws, are designed and manufactured to be used at masonry building sites, in particular to cut
until 20 cm high concrete blocks and other construction materials, mineral and compounds with at least one bearing
side (tile, terrazzo, brick, marble, granite, concrete or ceramics shingle, stoneware... The cutting tool is a diamond
disk powered by an electric motor and water cooled by a closed-circuit pump. The progress of the disk is done
manually by moving the cutting head in the direction of the material to be cut. The DAKAR MK45 models are
manufactured of high quality materials.
Any use other than the machine has been designed for is considered inappropriate and can be
dangerous; therefore, it is expressly prohibited.
Enable to move the head up and down directions easily and manually way, through turning and blocking the
•
head using the handle proportionate for the purpose
The head of the motor keep the right balance even when the block is cancel due a spring.
•
Its steel chassis avoid vibrations during cutting. Therefore we get a better efficiency of the diamond blade.
•
The sliding cart is supported by four wheels which roll over two rolling tracks build with a "U" frame. A rubber
•
protection is dispose on the sliding cart in its upper side to avoid the sliding of the material being cut.
The machine has four demountable legs to facilitate its transport and handles for its displacement.
•
It has been furnished with a graduated ruler to cut pieces in angles. It carries out mitre-cuts up to 45º.
•
The machine is protected with an anti-splatter screen to avoid the water splashing towards the back part of
•
the machine where the cutting is being performed.
The frame of the machine is painted with a highly resistant anti-corrosion epoxy polyester paint.
•
This machine has been designed and manufactured to cut with a water cooled diamond disk. The cooling is
•
carried out by a closed-circuit electric pump with a constant water flow.
The electric pump with a high impedance winding avoids its burning in normal conditions of use and certainly
•
that it is always covered with water.
Bearings´ electric motors are mounted with a high waterproof grade in order to guarantee long live to its
•
elements.
5
ENGLISH