Cutting Lenght Switch; Realising 45º Cut; Cutting In Downward Motion - Sima DAKAR MK45 Manual De Instrucciones

9.6 CUTTING LENGHT SWITCH

To change the length of cut when is more convenient to work when the cut length is small, DAKAR MK45 has
the ability to move the cutting unit along the side of the machine. To change the cutting length proceed as follows.
• Loosen the 4 screws as shown on the sticker.
• Move the cutting unit to the desired position and retighten the screws.
9.7 REALISING 45º CUT

9.8 CUTTING IN DOWNWARD MOTION

The design of the cutter DAKAR MK45 model allows cutting maintaining
the sliding cart fixed and making progress with a downward motion of the
cutting unit. This mode is very useful to make interior windows in one piece.
To make this type of cut we loosen the bolt till the unit is freed and the
internal spring tension will draw up its highest point
Then we will move the sliding cart with the work piece on to a position below
the disc and proceed to cut holding the bolt and pushing to cut down against
the resistance of the spring.
The advance shall be adjusted depending on material hardness and depth of
cut.
Excessive reduction of the disk could potentially damage the sliding
tray so the machine incorporates a screw cap which is regulated so that the
downward movement does not exceed the need to cut the media. Similarly
this cap determines the position of the horizontal plane of the cutting head,
which is a precondition to turn 45 degrees without causing a deflection of
the disk.
15
ENGLISH