Koenic KDW 60121 A2 BI Manual De Instrucciones página 23

Size - A5
Connect the power plug to the mains.
11
The dishwasher must be placed in the
12
installation position so that it is absolutely
level.
• The rear stands can be adjusted in height
by turning the middle Phillips screw
(Pos. A). Please refer to the figure next to
the screw (UP: rear is raised, DOWN: rear
is lowered).
• The front feet can be adjusted by turning
them by hand.
• Check the horizontal stand with a spirit
level on horizontal or vertical surfaces in
the interior of the dishwasher and the
door.
Place the dishwasher into final position.
13
The dishwasher must be fastened with
14
screws in the mounting position.
I. Wood Countertop: Insert the mounting
bracket on top of the cut-outs. Now screw
the mounting bracket to the underside of
the countertop.
II. Natural stone countertop: Remove
the plastic cap of the side walls of the
dishwasher (door open). Fasten the
dishwasher laterally with the screws
through the openings of the cabinets left
and right from the dishwasher.
Note:
Before using the product for the first time,
make sure, that all hydrophilic connections
of the product are correctly sealed and
connected to both the device as well as
the water mains. Check all connections
periodically to avoid possible leakage.
IM_KDW 60121 A2 BI_190411_V11_HR.indb 23
Preparation
Filling salt into the salt container
Fig. Depending on your tap water hardness
2
(hardness degree) use additional salt
(water softener). Always consider the
instructions provided with the salt.
• Remove the basket and then
unscrew and remove the cap from
the salt container.
• Before first usage, pour 1.5 lt. of
water in the salt container of your
machine.
• Place the end of the funnel
(supplied) into the hole and pour in
about 1.5 kg of salt. It is normal for a
small amount of water to come out
of the salt container.
• After filling the container, screw the
cap tightly back clockwise.
• Immediately after filling the salt
into the salt container, a washing
program should be started (rapid
program suggested). Otherwise
the filter system, pump or other
important parts of the machine may
be damaged by salty water which
will void the warranty.
Note:
Depending on how fully the salt dissolves,
the salt warning light may still be on even
though the salt container is filled.
English
23
11/4/2019 10:08