Koenic KDW 60121 A2 BI Manual De Instrucciones página 28

Size - A5
English
6. To start the washing process at a
later time, press the timer
buttons and by pressing them several
times set the hours by which the
start is to be delayed. 1-24 hours
(1 hour steps) start time delay can
be set. Then press the
The dishwasher starts the previously
selected program when the preset
time has elapsed.
Note:
The program lights show the state
of the dishwasher:
• Program light on: standby or
pause.
7. When the working cycle has finished,
the buzzer of the dishwasher will
sound for 8 seconds, then stop.
- Turn off the appliance using the
on/off button and shut off the
water supply.
- Open the door of the dishwasher.
It is dangerous to open the door
during an ongoing cycle, because
the hot water may scald you.
- Wait a few minutes before
unloading the dishwasher to avoid
handling the dishes and utensils
while they are still hot. They will
also dry better.
- Unload the dishwasher.
28
IM_KDW 60121 A2 BI_190411_V11_HR.indb 28
or
button.
Warning
Modify the washing program
You can modify the washing program when
the dishwasher has only been running for a
short time. Otherwise, the detergent may have
already been released, and the appliance may
have already drained the wash water.
• Press the button, the machine will
switch to the stand by state.
• Press the Programm selection button P
for more than three seconds. Change the
program to the desired cycle setting.
• Press the button again to continue the
washing process.
Note:
If you open the door during an ongoing cycle,
the machine will pause. When you close the
door, the machine will continue working after
10 seconds.
Pausing the washing cycle
• If you forgot a dish you can pause the
process and add it, but make sure the
detergent compartment has not already
opened.
1. Open the door a little to pause the
washing process.
2. After the spray arms came to a halt, you
can open the door completely.
3. Add forgotten dishes.
4. Close the door and the dishwasher will
continue after 10 seconds.
Child lock
• The child lock can be activated when the
dishwasher is running or started with the
start time delay.
• Press the timer buttons
simultaneously for 3 seconds. All keys
of the dishwasher are locked and the
corresponding indicator light
deactivate child lock, press the two buttons
again for 3 seconds.
Size -
is on. To
11/4/2019 10:08