Koenic KDW 60121 A2 BI Manual De Instrucciones página 30

Size - A5
English
Cleaning and care
Warning
• When cleaning, never use solvents or
abrasive materials, hard brushes, metallic
or sharp objects. Solvents are harmful to
human health and can attack plastic parts,
while abrasive cleaning mechanisms and
tools may scratch the surface(s).
• Clean the exterior surfaces of the product
with a slightly damp cloth and dry them
well. Make sure that no water enters the
product interior (e.g. at the switches).
• Clean the edge around the door using a
soft, warm and damp cloth only. To avoid
penetration of water into the door lock
and electrical components, do not use a
spray cleaner of any kind.
Cleaning the filter assembly
The filter prevents larger remnants of food or
other objects from getting inside the pump.
Inspect the filters for blocking every time the
dishwasher has been used.
The filter system consists of a coarse
Fig.
10
filter, a flat (main filter) and a micro
filter (fine filter).
• Main filter A: Food and soil particles
trapped by this filter are pulverized
by a special jet on the spray arm and
washed down to drain.
• Fine filter B: This filter holds soil
and food residue in the sump area
and prevents it from being spread
out over the dishes during a wash
cycle.
• Coarse filter C: Larger items, such
as pieces of bones or glass that could
block the drain are trapped in the
coarse filter. To remove the items
caught by the filter, gently squeeze
the tap on the top of this filter and
lift it up.
30
IM_KDW 60121 A2 BI_190411_V11_HR.indb 30
Disassemble and clean the filter
according to following steps:
• Turn the filter cap (filter C)
counterclockwise and take off the
whole filter assembly.
• Take out filters B and C.
• Wash filters under running water.
• Reassembling is done in reverse
order. Make sure the filter system is
installed correctly.
Warning
Do not use the dishwasher if the filter
system is not installed.
Cleaning the spray arms
To prevent possible clogging the spray
Fig.
11
arms can be easily removed for periodic
cleaning of the nozzles.
• Grasp the middle of the spray arm,
pull it upwards to remove it.
• Wash the arms under a jet of running
water.
• Return them carefully to their seat
and make sure that the spray arms
are installed correctly and can turn
freely.
Size -
11/4/2019 10:08