How To Assemble The Fan Blades - Fanimation The Sandella MAD3260 Serie Manual De Propietario

How to Assemble the Fan Blades

1. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom
edge of the blade is fully seated against the blade arm.
With a Phillips screwdriver, tighten 3/16-24 x 10 mm
phillips head screws to secure the blade to the blade
arm (Figure 18).
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Secure the blade holders to the motor support
using the 1/4-20 x 14 mm screws through the holes
located on the side of the motor support (Figure 19).
NOTE: Periodically check blade holder hardware and
resecure if necessary.
WARNING
NOTE:
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
3. Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws.
Assemble the light plate assembly to the support
bracket using the two key slots in the socket plate.
Replace the third screw and securely tighten all three
screws (Figure 20).
Blade Holder Arm
HARDWARE USED:
3/16-24 x 10 mm
PHILLIPS HEAD
SCREWS
HARDWARE USED:
1/4-20 x 14mm
SCREWS
10
Blade Holder
Cover
Figure 18
x 10
Figure 19
x 10
Light Plate Assemby
Figure 20