Whirlpool WHSS 90F TS K Instrucciones De Uso página 15

Press to activate or deactivate the "ZEN" extraction mode.
This function makes it possible to activate an extraction speed with the perfect balance between quietness and extraction efficiency.
T4. MOTOR ON/OFF
Press to switch the extraction motor on or off.
• With the motor on, use your finger to swipe right or left over the SL2 LED strip to increase or decrease the extraction speed.
T5. "POWER BOOST 1" FUNCTION
With the extraction motor on, press T5 to activate the "POWER BOOST 1" intensive extraction speed (time-controlled).
Please note: the hood will go back to running at the speed it was previously using after five minutes.
T6. "POWER BOOST 2" FUNCTION"
With the extraction motor on, press T6 to activate the "POWER BOOST 2" intensive extraction speed (time-controlled).
Please note: the hood will go back to running at the speed it was previously using after five minutes.
T7. AUTOMATIC MODE "COOK SENSE"
The hood will increase the extraction speed to 1 automatically if the sensor in the hood detects that the ambient conditions require
this.
If the ambient conditions do not change – and the hood is already using extraction speed 1 – the hood will switch off after five
minutes.
Please note: to make sure this function is used correctly, please configure the parameters for automatic mode first as described
in the relevant section.
Please note: when using automatic mode, if you change any other
functions that control the speed, the "Cook Sense" function will switch off.
T8. FILTER SATURATION INDICATORS
At regular intervals, the hood signals the need to perform filter maintenance.
Please note: The indicators will only work when the hood is on.
T8 button lit: Carry out maintenance on the grease filter.
T8 button flashing: carry out maintenance of the charcoal filter.
Resetting the filter saturation indicators:
Please note: This must be done with the hood switched on.
Press and hold the T8 button.
Activating the carbon filter saturation indicator
Please note: This must be done with the extraction motor switched off.
This indicator is usually deactivated – press and hold the T3 and T10 buttons simultaneously to activate the function: The buttons will
light up to indicate activation.
To deactivate the function, press and hold the same buttons (T3 and T10) again: The buttons will flash briefly and then switch off to
indicate deactivation.
T9. ON/OFF OPERATING MODE "DAILY AIR SENSE"
The hood will increase the extraction speed to 1 automatically if the sensor in the hood detects that the ambient conditions require
this.
If the extraction speed does not change owing to the ambient conditions detected, the hood will switch off after two hours.
The hood will switch off in any case after five hours in use, regardless of the operating mode.
Please note: to make sure this function is used correctly, please configure the parameters for automatic mode first as described
in the relevant section.
T10. ON/OFF OPERATING MODE " INTENSIVE AIR SENSE "
The hood will increase the extraction speed to 5 automatically if the sensor in the hood detects that the ambient conditions require
this.
If the extraction speed does not change owing to the ambient conditions detected, the hood will switch off after two hours.
The hood will switch off in any case after five hours in use, regardless of the operating mode.
Please note: to make sure this function is used correctly, please configure the parameters for automatic mode first as described
in the relevant section.
CONFIGURING THE PARAMETERS FOR AUTOMATIC MODE
To make sure that automatic mode is used correctly, you will need to calibrate the hood and select the hob type.
15