Placing Tool In Service - Ingersoll Rand CA-EU Serie Manual De Instrucciones

WARNING: Incorrect combinations of grinding wheel, wheel guard and tool speed could result in injury. Correct
combinations are specified below:
Guard Part Number
AG20–106–3
LUBRICATION
Ingersoll–Rand No. 10
Ingersoll–Rand No. 50
Ingersoll–Rand No. 63
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International – No. C16–C3–A29
After each two hours of operation, if an air line lubricator is
not used, inject 1/2 to 1 cc of Ingersoll–Rand No. 10 Oil into
the Air Inlet.
After each eight hours of operation, inject approximately
1 cc of Ingersoll–Rand No. 67 or Ingersoll–Rand No. 77
Grease into the Angle Grease Fitting. Excessive lubrication
will cause grease to work out around the Arbor.
NEW GRINDER TO ACCESSORY COLOR MATCHING GUIDE
Ingersoll–Rand has pioneered a new color code system
designed to:
1. Simplify the identification of rated tool speed via a
unique corresponding color match.
2. Easily communicate the appropriate backing pads and
GRINDER SPECIFIC WARNINGS
Wheel Type Wheel Diameter
27

PLACING TOOL IN SERVICE

Ingersoll–Rand No. 67
Ingersoll–Rand No. 68
Ingersoll–Rand No. 77
(READ FROM LEFT TO RIGHT)
Maximum Wheel
in. (mm) Thickness
in. (mm)
3 (76) 1/4 (6.4)
Do not mark any nonmetallic surface of this tool with
customer identification codes. Such action could affect tool
performance.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
accessories for each tool through a matching color
code system on the backing pads and/or other
corresponding Grinder accessories.
3. The chart below demonstrates the color code system
between the Grinder and the accessory.
3
Maximum Speed
rpm
26 250
FILTER
COMPRESSOR
(Dwg. TPD905–1)
(Dwg. TPD1146–1)