Mounting Main Barrel To The Cart; Installing The Lid Stopper; Installing The Lid Handle - Navigator PIT BOSS PB550G Manual De Instrucciones

6. MOUNTING MAIN BARREL TO THE CART

Parts Required:
1 x Main Barrel (#4)
12 x Screw (#A)
Washer (#B)
12 x
Locking Washer (#C)
12 x
1 x Power Cord (#29)
1 x Cable Clip (#28)
Installation:
• Please replace with the correct power cord for your country, if you find
the power cord does not match the plug you are using.
• Place the cable clips on the correct power cord. Insert the power cord
into the grove at the bottom of the hopper. Secure the cable clip to
the bottom of the hopper with the previously installed screw. Note
Illustration 6A.
• Prepare the Main Barrel to be mounted to the cart. Carefully, lift the Cart
into an upright position with the Wheels on the bottom. Position the
Cart next to the Main Barrel, with both facing the same direction. Using
a second person, prepare to lift the Main Barrel onto the Cart. With one
person lifting from the hopper side, and the other person lifting from
the opposing barrel end, carefully lift the Main Barrel, and slowly lower
onto the cart. Note illustration 6B.
• Next, open the Main Barrel lid. Adjust the rotation as needed to align the
screw holes of the Main Barrel to the Cart. Once placed, secure each leg
to the Main Barrel using three Screws, Washers, and Locking Washers.
Note illustration 6C.

7. INSTALLING THE LID STOPPER

Parts Required:
Lid Stopper (#1)
1 x
Installation:
• Secure the Lid Stopper onto the top of the Main Barrel using the pre-
installed screw on top of the Main Barrel.

8. INSTALLING THE LID HANDLE

Parts Required:
Lid Handle (#2)
1 x
Lid Handle Bezel (#3)
2 x
Installation:
• Remove the pre-installed screws from the Lid Handle. From inside the
barrel lid, insert one screw protrude to the outside. Add a Bezel on
the screw. Then hand-tighten the screw (from the inside) into the Lid
Handle. Repeat for other side.
6A
28
29
6B
4
6C
A
C
B
7
1
8
3 3
2
7