Testing Your Fan - Craftmade C211 Guia De Instalacion

11. Testing Your Fan.

It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull
chain on the switch housing. Start at the OFF
position (no blade movement). First pull will set the
fan to HI. Second pull will set the fan to MEDIUM.
Third pull will set the fan to LOW. Fourth pull will
again set the fan to the OFF setting. Test light(s) with
the pull chain in the middle. If fan and/or light(s) do
(does) not function, please refer to
"Troubleshooting" section to solve any issues before
contacting Customer Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- DOWN position in summer (diagram 1)
- UP position in winter (diagram 2)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat
setting in winter without feeling a difference in your
comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to
function. If the reverse switch is set in the middle
position (diagram 3), fan will not operate.
Attach pull chain extensions supplied or custom pull
chain extensions (sold separately) to ends of the pull
chains.
reverse
switch
reverse
switch
diagram 1
page 10
chain extensions
chain extensions
diagram 2 diagram 3