3-Light Option - Craftmade C211 Guia De Instalacion

10. Light Kit Assembly, 3-light Option.
*For Model C215
Remove all 3 screws from switch housing cap
(at top of light kit fitter) and save them for
later use.
Locate BLUE (or BLACK) and WHITE wires in
switch housing labeled LIGHT. Remove and
discard plastic that holds these 2 wires
together.
Next, locate WHITE and BLACK wires in light
kit fitter labeled FOR LIGHT.
Connect WHITE wire from light kit fitter to
WHITE wire from switch housing. Connect
BLACK wire from light kit fitter to BLUE (or
BLACK) wire from switch housing. Be sure
molex connections snap together securely.
Align holes in light kit fitter with holes in
switch housing. [NOTE: The gap on the top
edge of the light kit fitter must align with
reverse switch on the switch housing for the
proper fit.] Attach light kit fitter with 3 screws
that were previously removed. Secure all
3 screws with a Phillips screwdriver.
Remove socket rings from socket. Attach
shades with socket rings provided. Do NOT
overtighten socket rings as shades may crack or
break.
Install bulbs included with light kit.
IMPORTANT: When replacing bulbs, please
allow bulbs and shades to cool down before
touching them.
Please proceed to Section 11 on the
following page to complete installation.
switch
housing
reverse
switch
shade
socket ring
bulb
page 9
motor housing
molex
connections
light kit fitter
switch
housing
molex
connections
light kit fitter
socket ring