brentwood H-C1601 Instrucciones De Operación Y Seguridad página 6

OFF-SEASON STORAGE INSTRUCTIONS
Secure the power cord, and place your heater in its original shipping
1.
container, or a similar container.
Store the container in a cool, dry location.
2.
SAFETY FEATURES
TIP-OVER PROTECTION
Your heater is equipped with a Tip-Over Safety Switch. When your heater
tips over, it will turn off automatically.
OVERHEAT PROTECTON
Your heater is equipped with an Overheat Protection System. When the
threshold temperature has been reached, your heater will turn off
automatically.
To reset your heater when the Overheat Protection System has been
activated, perform the following:
Turn the Power Control Switch to the 'O' position, and turn the
1.
Temperature Control Switch to the lowest setting.
Disconnect the power cord from the electrical outlet.
2.
Allow your heater to cool down for approximately ten minutes.
3.
Ensure that both the intake and the exhaust vents are clear of
4.
obstructions.
Connect the power cord to the electrical outlet.
5.
Turn the Power Control Switch to the 'II' position, and turn the
6.
Temperature Control Switch to the highest setting.
If your heater does not operate normally, turn the Power Control Switch to
7.
the '0' position, disconnect the power cord from the electrical outlet, and
consult an authorized repair technician.
TROUBLESHOOTING
If your heater fails to operate, perform the following:
Review this manual to ensure that you understand the basic operations and
1.
features of your heater.
Check your household circuit breaker or fuse.
2.
Check for obstructions at the intake and exhaust vents.
3.
If obstructions are present, refer to the instructions for resetting your
•
heater when the Overheat Protection System has been activated.
If no obstructions are present, and your heater still does not operate
•
normally, turn the Power Control Switch to the '0' position, disconnect
the power cord from the electrical outlet, and consult an authorized
repair technician.
6