Features; Assembly - RIDGID R8611501 Manual Del Operador

FEATURES

PRODUCT SPECIFICATIONS
Chuck ...........................................................1/2 in. Keyless
Motor .................................................................. 18 Volt DC
Switch ................................................ Variable Speed (VSR)
No Load Speed ....................... 0-450/0-1,600 r/min. (RPM)
KNOW YOUR HAMMER DRILL
See Figure 1, page 13.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
AUXILIARY HANDLE ASSEMBLY
Your drill is equipped with an auxiliary handle assembly that
can be installed in different positions.
BIT STORAGE
A bit provided with the drill can be placed in the storage
area, located on the base of the drill.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
Your drill has a direction of rotation (forward/reverse/center
lock) selector located above the switch trigger for changing
the direction of bit rotation. Setting the switch trigger in the
OFF (center lock) position helps reduce the possibility of
accidental starting when not in use.
IMPACT SPEED
This tool features an impact speed of 0-7,200 BPM (Blows
Per Minute) in LO (1) speed and 0-25,600 BPM in HI (2)
speed.

ASSEMBLY

UNPACKING
This product has been shipped completely assembled.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing
or damaged. Use of a product that is not properly
and completely assembled could result in serious
personal injury.
Blows per minute* ............................0-7,200/0-25,600 IPM
Clutch ................................................................ 24 Position
Torque ................................................................... 615 in.lb.
* Impacts per minute
KEYLESS CHUCK
The keyless chuck allows you to hand-tighten or release the
drill bit in the chuck jaws.
LED GRIP LIGHT
The LED light, located on the front of the tool base, illumi-
nates when either the switch trigger or grip light switch is
depressed.
MODE SELECTOR
With the mode selector, you can select drill, drive, or ham-
mer mode.
TORQUE ADJUSTMENT RING
Your drill has a 24-position clutch. The torque adjustment
ring can be turned to select the right amount of torque for
your application.
TWO-SPEED GEAR TRAIN
The two-speed gear train is designed for drilling or driving
at LO (1) or HI (2) speeds. A slide switch is located on top
of your drill for selecting either LO (1) or HI (2) speed.
VARIABLE SPEED
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
PACKING LIST
Hammer Drill
Auxiliary Handle Assembly
Double-ended Bit
Tool Bag
Operator's Manual
6 - English