Programming The Receiver Operating Frequency - Luminance Brands Kathy Ireland Home SWEEP ECO CF275BS00 El Manual Del Propietario

9. Programming the Receiver Operating Frequency

-- Important - Read This Section Carefully --
IMPORTANT: Ceiling fan blades MUST be installed
before programming can begin.
NOTE: If using a 3-way switch installation, ensure
that both wall controls are using the same switch
code.
9.1
Flip the Wall Control ON/OFF Switch (
"OFF" ( O ) position .
Restore Electricity to the Ceiling Fan Branch Circuit at
the Circuit Breaker or Fuse Box .
Flip the Wall Control ON/OFF Switch to "ON" (
position .
Within one minute of flipping the Switch to "ON", push
and hold the FAN OFF Button (
to set the Code in the Receiver . The Ceiling Fan Lights
(if installed) will blink to indicate the Wall Control Code
has been paired with the Receiver .
9.2
If programming is unsuccessful, retry the previous
instructions after cycling the Wall Control ON/OFF
Switch to restart the 1 minute programming time period .
If still unsuccessful, shut off the Electricity at the Fuse
Box or Breaker Panel and change the Wall Control
frequency (Section 7 .2, Page 16) .
) to the
After changing the frequency settings, repeat
instructions in Section 9 .1 within one minute of restoring
the electricity .
)
) for 3 to 5 seconds
21
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
ETL Model No.: CF275