Luminance Brands Kathy Ireland Home SWEEP ECO CF275BS00 El Manual Del Propietario página 9

3. Ceiling Fan Assembly
3.12
Route the two 80" Motor Wires through the Hanger Ball
(Figure 12) .
Reinstall the Hanger Ball on the Downrod as follows:
Position the Pin through the two holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
groove in the top of the Hanger Ball (Figure 12) .
Pull the Hanger Ball up tight against the Pin and
securely tighten the Phillips Set Screw in the Hanger
Ball (Figure 12) .
NOTE: A loose Set Screw could create Fan wobble.
3.13
The fan comes with Black and White Wires that are
80-inches long .
Measure up approximately 6 to 9-inches above top of
Hanger Ball / 8" Downrod Assembly (Figure 13) .
Cut off excess wires and strip back insulation 1/2-inch
from end of wires .
You have now partially completed the assembly of your
new ceiling fan, proceed to How to Hang Your Ceiling
Fan . Final Assembly of the ceiling fan will be completed
once ceiling fan is hung and wired .
(Continued)
PIN
HANGER
BALL
Figure 12
1/2-INCH
6 TO 9
INCHES
Figure 13
9
DOWNROD
CEILING
COVER
PHILLIPS
SET SCREW
BLACK WIRE
WHITE WIRE
HANGER BALL
luminancebrands.com
Please contact 1-800-777-4440 for further assistance
ETL Model No.: CF275