Klarstein VINSIDER 35D Manual De Instrucciones página 27

Notes on the power connection
• Before use, check the voltage on the device label and connect the device only to
sockets which correspond to the voltage of the device.
• The device can be connected to sockets with a voltage of 220-240 V ~ 50 Hz.
If you are not sure whether your connections meet the requirements, consult an
electrician or your power supplier.
• The cable should run safely behind the unit. Only connect the appliance to sockets
to which no other electrical appliances are connected. Do not pull the plug out of
the socket by the cable, but hold it by hand when pulling it off.
• If the power cord is damaged, it must be replaced by the manufacturer or an
authorized service center or a similarly qualified person.
• Do not connect the equipment to extension cords that have not been specifically
tested and recommended by a technician.
EN
27