Blackstone 1565 El Manual Del Propietario página 7

Model 1565 | Owner's Manual | Assembly Guide
S T E P 0 4 With the help of another person
wheels. Then, with four (4) M6 bolts, attach the handle to the left side of the
griddle body.
S T E P 0 5 With the help of another person
griddle body by aligning the four pins to the holes on top of the body. Make
sure the pins are fully seated in the holes. Place the grease cup on the back of
the griddle body in the center of the unit.
10
BAT TERY POWERED IGNITION
TROUBLESHOOTING
SYMPTOMS
01. Burner will not Light with ignition system
02. Pressing the ignition button does not result in a clicking sound
If ignition does not occur in 5 seconds, turn the burner controls off, wait 5
CLEANING THE GRIDDLE COOKING SURFACE
S T E P 0 6
, place the griddle on its
minutes and repeat the lighting procedure. If this does not work, to deter-
M6x38 screws to attach the upper hanger and secure it from the back with
mine the cause, please try to ignite your griddle with a match. (Please
two (2) M6 nuts. Then, use two (2) M6x38 screws to attach the lower hanger
reference the Match Lighting Instructions in the Cleaning the Burner
and secure it from the back with two (2) M6 nuts.
Assembly section of the Care & Maintenance chapter.)
If you CAN ignite your griddle with a match
POSSIBLE CAUSES
01. Dead battery or no battery.
02. Battery installed incorrectly.
03. Igniter wire misaligned.
, place the griddle top onto the
04. Damage to the ignition system.
S T E P 0 7
beneath the Ignition Button until tight, be careful not to over tighten.
If you CAN NOT ignite your griddle with a match
Connect the 20lb propane tank (not included). (Please reference the
Connection & Removal section of the Fuel | Propane – 20lb. Tank chapter.) POSSIBLE CAUSES
05. Burner tubes are not
S T E P 0 8 Proceed to the Griddle Seasoning Instructions section of the
Care & Maintenance chapter.
Griddle Cooking Station!
Attach the upper and lower propane tank hanger. Use two (2)
S T E P 0 1
To clean griddle after
each use, cool griddle below 300° F.
Scrape food debris with spatula or
straight metal scraper.
S T E P 0 2
Wipe down griddle
SOLUTION
surface with paper towel.
Replace with new battery.
Ensure that the battery is installed nega-
tive end first.
S T E P 0 3
Ensure that the igniter wire is posi- Divide griddle surface
tioned 1/8" to 1/4" away from the burner
into approximately 6" sections
tube, positioned above a burner hole.
(width of scraper tool). Apply a
small amount of water onto first
Contact customer service for replace-
section with a bottle and then
ment parts.
scrape the water and debris toward
Insert one AA battery (not included) into the battery socket
the grease trap. Move to the next 6"
section and repeat.
SOLUTION
DO NOT USE MORE THAN TWO
TABLESPOONS OF WATER
Please reference the Gas Flow section of
receiving propane. AT A TIME. the Troubleshooting Chapter.
Enjoy cooking outdoors on your Blackstone 36"
1/4 cup of table salt may be used to
buff off stuck food residue.
S T E P 0 4
Wipe again with a
paper towel and dry completely.
S T E P 0 5
Apply thin coat of
cooking oil to maintain seasoning
and protect the griddle top.
Care & Maintenance Assembly Guide | Owner's Manual | Model 1565
!
WA R N I N G
NEVER APPLY COLD
WATER ACROSS THE
WHOLE SURFACE OF A
HOT GRIDDLE AT ONCE.
This may cause warping.
!
C A U T I O N
DO NOT USE SOAP ON
THE GRIDDLE COOKING
SURFACE. This will destroy
the griddle's seasoning.
Insert one AA battery (not included)
into the battery socket with the posi-
tive terminal facing out, then screw
on the Ignition Button until tight. Be
careful to not over tighten.
NEED HELP? Register your Blackstone
product at blackstoneproducts.com/
pages/register-product and contact
Blackstone Customer Service for missing
parts, assembly and operation questions:
 PHONE:
435-252-3030 ext 1
EMAIL:
support@blackstoneproducts.com
ONLINE:
blackstoneproducts.com/pages/
customer-support
11