Panasonic KX-TWA50EX Manual De Instalación página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
TWA50EX(ex).book Page 5 Monday, June 16, 2008 4:21 PM
• When replacing the batteries:
- USE ONLY rechargeable Ni-MH batteries AAA (R03) size.
- Do NOT use Alkaline/Manganese/Ni-Cd batteries.
- We recommend using the Panasonic rechargeable batteries noted in the base
unit's operating instructions for replacement battery information.
Place the handset on the charger for about 7 hours before initial use.
Note:
• If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
,
S
T
charge again.
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold {ih} for
few seconds to turn the handset on.
1
Handset:
{j/OK}
2
{V}/{^}: "Settings" i {>}
3
{V}/{^}: "Registration" i {>}
4
{V}/{^}: "Register H.set" i {>}
5
Base unit:
Press and hold {x} for about 5 seconds. (No registration tone)
• The GSM network indicator on the base unit starts flashing green.
• If all registered handsets start ringing, press the same button to stop. Then
repeat this step.
6
Handset:
When the handset has been registered successfully, you hear a confirmation
tone (long beep) and w stops flashing.
For your safety
To prevent severe injury and loss of life/property, read this section carefully
before using the product to ensure proper and safe operation of your product.
WARNING
Power connection
• Completely insert the AC adaptor/power plug into the power outlet. Failure to
do so may cause electric shock and/or excessive heat resulting in a fire.
• Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it
from the power outlet, then wiping with a dry cloth. Accumulated dust may
cause an insulation defect from moisture, etc. resulting in a fire.
) and the charge contacts with a dry cloth and
5

Publicidad

Tabla de contenido
loading

Tabla de contenido