Care And Cleaning; Troubleshooting - Home Decorators Collection JAQ1691L-2 Guía De Uso Y Mantenimiento

Care and Cleaning

Clean the fixture with a soft, dry cloth.
Do not use any cleaners with chemicals, solvents or hash abrasives.
WARNING: Before attempting to clean the fixture,
disconnect the power to the fixture by turning the breaker off
or removing the fuse from the fuse box.

Troubleshooting

Problem
In motion sensing mode,
the light does not turn on
when there is motion.
In motion sensing mode,
the light stays on
continuously.
The light comes on for no
apparent reason.
The light comes on during
the daytime or too early in
the evening.
Possible Cause
The wall switch or circuit breaker is off.
Incorrect or loose wire connections.
Too much sunlight is shining onto the photocell
sensor in the early evening.
Too much light is shining onto the photocell sensor
due to another light source, such as a street lamp
or other light fixture.
Moving people or vehicles are below the view of the
motion sensor, because the motion sensor is
mounted too high.
There is false triggering caused by a heat source,
such as a heater or dryer vent, or heated swimming
pool.
Street or sidewalk traffic is triggering the motion
sensor.
There is false triggering caused by a heat source,
such as a heater or dryer vent, or heated swimming
pool.
The fixture may be installed in a shaded area, such
as under a porch or eave, preventing daylight from
shining onto the photocell sensor.
9
Please contact 1-800-986-3460 for further assistance.
Solution
Turn on a switch or circuit breaker.
Check the wire connections.
Relocate the fixture away from a
western facing wall.
Eliminate or turn off other light
source, block other light source from
shining onto photocell sensor, or
relocate the fixture.
Relocate the fixture to a lower
position or to a different location.
Eliminate the heat source or relocate
the fixture.
Lower the sensitivity.
Eliminate the heat source or relocate
the fixture.
Relocate the fixture.
HOMEDEPOT.COM/HOMEDECORATORS