Dyna-Glo DGA480SSN Manual Del Usuario página 8

ASSEMBLY INSTRUCTIONS
3. Insert one screw (AA) halfway into the middle
rear threaded hole on both the cart left side
panel (D) and cart right side panel (E). Attach
the cart rear panel (F) by sliding the keyholes
in the cart rear panel (F) over the inserted
screws. Slide the cart rear panel (F) down to
meet bottom shelf (A). Secure the cart rear
panel (F) to the bottom shelf (A) with 3 screws
(AA). Tighten all screws, including the 2
screws in cart side panels (D and E).
Hardware Used
AA
M6 x 12 Screw
4. Insert 2 screws (AA) halfway into the top
front threaded holes of both the cart left side
panel (D) and the cart right side panel (E).
Attach the upper door brace (G) by sliding
the cut-outs in the upper door brace (G)
over the 4 screws (AA) and tightening all 4
screws (AA).
Hardware Used
AA
M6 x 12 Screw
3
D
x 5
4
AA
x 4
8
AA
F
A
AA
AA
E
G
E
G
D