Publicidad
Idiomas disponibles
Idiomas disponibles
Daily Use
Troubleshooting
Caution! The Before troubleshooting, disconnect the power supply. Only a qualified electrician
of ( » ) competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not work
The food is too warm.
Appliance cools too much Temperature is set too cold.
Unusual noises
Water on the floor
Side panels are hot.
If the malfunction shows again, contact the Service Center.
Possible cause
Temperature regulation knob is set at Set the knob at other number to switch on
Mains plug is not plugged in or is
loose
Fuse has blown or is defective
Socket is defective
Temperature is not properly adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the last
24 hours.
The appliance is near a heat source.
Appliance is not level.
The appliance is touching the wall or
other objects.
A component, e.g. a pipe, on the rear
of the appliance is touching another
part of the appliance or the wall.
Water drain hole is blocked.
Condenser is inside the panel
Solution
the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be corrected by
an electrician.
Please look in the initial Temperature
Setting section.
Open the door only as long as necessary.
Turn the temperature regulation to a colder
setting temporarily.
Please look in the installation location
section.
Turn the temperature regulation knob to a
warmer setting temporarily.
Re-adjust the feet.
Move the appliance slightly.
If
necessary,
component out of the way.
See the Cleaning section.
19
carefully
bend
.
the
Publicidad
