Mark MOVILED 183 W Instrucciones De Usuario página 6

EN
Master/slave-operation
The master/slave-operation enables that several devices can be synchronized and controlled by one
master-device
DMX controlled operation
You can control the projectors individually via your DMX-controller
Addressing
The control board allows you to assign the DMX starting address,
Note;it's necessary to insert the XLR termination plug (with 120ohm) in the last device in the link in order
to ensure proper transmission on the DMX data link.
C ONT R O L B O AR D
The control board offer several features :you can simple set the starting address, run the
pre-programmed program or make a reset
he main menu is accessed by pressing the Mode/Esc-button, Browse through the submenu by pressing
Up or Down .Press the Enter-button in order to select the desired menu. You can change the selection
by pressing Up or Down, Confirm every selection by pressing the Enter-button. You can leave every
mode by pressing the Mode/Esc-button .The functions provided are described in the following setting.
M EN U M AP
The device has two operation modes, It can be operated in Stand Alone or in DMX controlled
A001 (address code setting from A001-------A512)
AU01(auto-moving speediness)
SN01(Sound control for color changing)
RPOF(Set pan to forward-rotating)
RTOF(Set tilt to forward-rotating)
RDOF(set the LED readout to non-inverting)
DFON (Default output setting)
Note：output default setting address code is A001, pan is positive circumrotate、tilt is positive
circumrotate、LED positively reveal.
MOVILED 183 W
AU02(slow speed auto-moving)
SN02( Sound control for strobe)
RPON(Set pan circumrotate reverse)
RTON(Set tilt circumrotate reverse)
RDON(Set the LED readout to inverting)
User Manual/Manual de uso Page 4