Mark MOVILED 1210 B Instrucciones De Usuario página 5

> Exact positioning via 16 bit PAN/TILT movement resolution
> Automatic position correction
> DMX-controlled operation or stand-alone operation with Master/Slave function
> Sound-control via built-in microphone
> Control board with graphic LCD display for adjusting the DMX-starting address, PAN/TILT reverse,
program, reset, operating hours
> Switch-mode power supply
> Automatic power supply adaption between 100 and 240 Volts without power selector
INSTALLATION
Rigging
The installation of the projector has to be built and constructed in a way that it can hold 10 times the
weight for 1 hour without any harming deformation.
IMPORTANT!OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including calculating
working load limits, installation material being used, and periodic safety inspection of all installation
material and the projector. If you lack these qualifications, do not attempt the installation yourself, but
instead use a professional structural rigger. Improper installation can result in bodily injury and or
damage to property. The projector had to be installed out of the reach of people
DANGER OF FIRE! When installing the device, make sure there is no highly-inflammable
material(decoration articles, etc.)within a distance of min.0.5m.
DMX 512 connection/ connection between fixture
The wires must not come into contact with each other, otherwise the fixture will not work at all or
properly. Please note the starting address depends upon which controller is being used. Only use a
DMX cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture or one
fixture to another
Connection with the mains.
MOVILED 1210 B User Manual/Manual de uso
EN
Page 3