Wiring Plan; Functional Test - Westfalia 300 073 300 113 Instrucciones De Montaje

The brown/white lead for disabling the parking aid is switched to earth for connected towed
vehicles and is only suitable for parking aids which can be deactivated by an activated earth.
Further information may be obtained from your workshop.
As illustrated in the wiring plan, all other wires are to be worn away at the respective vehicle
wires with cutter connectors.
It is essential to ensure that the cutter connectors are installed by a qualified person. The wire
connectors are to be closed off in the wires after the cutting. If the wire cross-sections of the
vehicle's wires are not between 0.75 and 1.0 mm
should be used.

Wiring plan:

Vehicle function:
Left flash relay
Left turn signal
Brake light
Left taillight
Right flash relay
Right turn signal
Right taillight
Fog light, switch
Parking aid disabler
Fog light, taillight
Earth
Continuous positive +12V for control unit red, 10A protected
Reverse lamp

Functional test:

Re-connect the earth wire to the battery.
Check that the electrical system is functioning properly. Use a trailer or suitable testing instru-
ment with load resistance to test the electrical system. The control unit may malfunction if a
testing instrument without load resistance is used.
The continuous positive extension set for the 13-pin electrical system is available in automotive
supply stores under the Westfalia parts no. 300 025 300 113.
, cutter connectors other than those supplied
2
Cable bundle wire colour:
yellow
green/white
black/red
gray/black
red/green
gray/yellow
gray/red
blue
brown/white
gray
brown
green
GB
Cross-section:
1.0
1.0
1.0
0.75
1.0
1.0
0.75
0.75
0.5
0.75
1.5 / 2.5
1.5
0.75
29