Paper Shredder Hsm Shredstar X13 - HSM shredstar X13 Instrucciones De Servicio

6 Cleaning and maintenance
Switch off the shredder and pull out the mains
plug. When cleaning only use a soft cloth and
a mild soap-water solution. However, no water
may enter the equipment.
Oil the cutting unit when
cutting performance deterio-
rates or the device becomes
noisy, or every time you
empty the waste container.
• Squirt special cutting unit oil through the
paper feed across the entire width of the
cutting shafts.
• Without feeding in paper, run the cutting unit
in reverse (REV).
 This loosens paper dust and particles.
8 Technical data
Cutting type
Shred size
Sa fe ty ra ting German DIN 66399
Cutting ca pa ci ty
Lo ading width
Cutting speed
Voltage
Power
Dimensions W x D x H (mm)
Weight
Volume of shred. mat. container
Noise level (Idle running/ load)
EC Declaration of Conformity
HSM GmbH + Co. KG, Austraße 1-9, 88699 Frickingen / Germany hereby declares that the machine
document shredder HSM shredstar X13 corresponds to the health and safety requirements of the following EC direc-
tives listed below due to its conception and design of the version in which it was put into circulation by us:
Low voltage directive 2006 / 95 / EEC
EMC directive 2004 / 108 / EC
Applied standards and technical specifi cations:
• EN 13857:2008
• EN 55014-2:1997 + A1:2001 + A2:2008
• EN 61000-3-3:2008
Frickingen, 17.10.2013
10
• EN 55014-1:2006 + A1:2009
• EN 61000-3-2:2006 + A1:2009 + A2:2009
ppa. Hubert Kötzinger - Head of Environmental Engineering Product Development
shredstar X13
7 Disposal / Recycling
Electrical and electronic old devices
contain a variety of valuable materi-
als, but also hazardous substances
which were required for function and
safety. Incorrect disposal or handling
can be dangerous to your health and
the environment. Never dispose of old devices
in the household waste. Observe the current
applicable regulations and use the collection
points for returning and recycling electric and
electronic devices. Dispose of all the packaging
materials also in an environmentally-responsi-
ble way.
Cross cut
4 x 37 mm
P-4 / O-3 / T-4 / E-2 / F-1
13 sheets of paper (80 g/m²) or 1 CD (max. 1.2 mm thick)
or 1 credit card / store card
222 mm
47 mm/s
220 - 240 V / 50 - 60 Hz
360 x 285 x 545
10.4 kg
58 dB(A) / 65 dB(A)
english
250 W
23 l
06/2014