Before The First Use - Domo DO7106S Manual De Instrucciones

preheated, the steam light will light up blue, indicating you may start ironing.
Steam release button
When the light indicator lights up blue, you can start using steam. Press the steam release
button on the inside of the handle of the iron to spray a continuous steam out of the soleplate.
When you let go of the button, you will iron dry again, without steam.
Descaling cartridges
We advise you in changing the descaling cartridges after 3 months. In order to replace the
descaling cartridge, you need to remove the water tank and remove the old cartridge and
insert a new one in the same place.
Attention: A new descaling cartridge is best left soaking in a small container of water for an
entire night. This ensures it's wet enough to allow you to iron immediately after changing the
cartridges out.
Cord clamp
After use you can easily store the cord and steam hose by using the cord clamp. Pull out the
clamp, lead the steam hose and the cord around the steam generator and push in the clamp
to lock the cord and steam hose.
Temperature dial
Set the right temperature for the right fabric with the temperature dial.
For synthetic fabrics/silk:
For wool:
For cotton:
For linnen:

BEFORE THE FIRST USE

1. Remove any stickers or protective foil from the soleplate.
2. Heat up the iron until the maximum temperature and iron on a damp cloth during a
couple of minutes to remove any possible residues from the soleplate. Iron according to
the instructions in the section «Steam ironing».
Caution:
· During the first use it is normal that a specific odeur escapes from the appliance. This odeur
will disappear after a while.
· Some particles may come out of the soleplate during the first use. This is normal. The
www.domo-elektro.be
70<T<120°
100<T<160°
140<T<210°
170<T<225° MAX
35
DO7106S