Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7
7B
7A
HOT
7 WATER SUPPLY CONNECTIONS
Connect water Supply Lines (7A) to Faucet Inlets (7B). Hot water supply lines go into
left inlet. Cold water supply lines go into right inlet. (Supply lines are not included).
Please follow manufacturer's instructions when installing supply lines.
8
8 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
FAUCET FUNCTIONS
9
HOT
OPEN
9A
9 FAUCET FUNCTIONS
COLD valve: close-counterclockwise, open-clockwise; HOT valve: close-clockwise,
open-counterclockwise. The Spout (9A) can be rotated around the Faucet Body in
any direction.
Note: Flush faucet before turning on valve (see step 11).
7B
7A
COLD
COLD
OPEN
ENGLISH
10
10 SIDE SPRAY OPERATION
The Side Spray (10A) can be pulled forward to spray water in any direction. To activate
the Side Spray, press the Toggle Button (10B) located on the back of the Side Spray (10A).
MAINTENANCE & CARE
11
11E
11D
11C
11 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (11A). Turn Valves (11B) on
and allow both hot and cold water to run for at least one minute each. While water is
running, check for leaks. To clean the aerator, disassemble Aerator Housing (11A) by
separating the Aerator Shell (11C), Basket (11D) and Washer (11E). Once parts have
been cleaned, reassemble by reversing steps.
3
10B
10A
11B
11A
Publicidad
Tabla de contenido
