Working Safely - Festo MPS 8038802 Manual Del Usario

Separating station

The MPS may only be used:

For its intended purpose

When its safety functions are in flawless condition
Malfunctions which may impair safety must be eliminated immediately!

4.5 Working safely

General information

Trainees may only work with the circuits under the supervision of a trainer.

Electrical devices (e.g. power supply units, compressors and hydraulic power units) may only be
operated in training rooms which are equipped with residual current devices (RCDs).

Observe the specifications included in the technical data for the individual components, and in
particular all safety instructions!

Malfunctions which may impair safety must not be generated in the training environment, and must be
eliminated immediately.

Wear personal protective equipment (safety goggles, safety shoes) when working on circuits.
Mechanical safety

Switch off the power supply!
– Switch off the working as well as the control power before working on the circuit.
– Only reach into the setup when it's at a complete standstill.
– Observe possible overruning of the drives.

Mount all of the components securely onto the slotted profile plate.

Make sure that limit switches are not actuated from the front.

Risk of injury during troubleshooting!
Use a tool to actuate the limit switches, for example a screwdriver.

Set all components up so that activation of switches and disconnectors is not made difficult.

Follow to the instructions regarding positioning of the components.
28
© Festo Didactic 8038803