Fagor 3LVF-638IT Manual De Instrucciones página 115

Stop using multi-component detergents
Add special salt and rinse aid to dispensers.
Set the water hardness to the highest level (6) and run an empty dishwasher.
Adjust the water hardness.
Adjust rinse aid setting.
Add rinse aid to the dispenser and adjust setting
8
Use rinse aid to prevent the formation of white water drops, lime scale spots, white
streaks that may occur on the dishes, as well as to improve the drying process. Con-
trary to popular belief, it not only serves to obtain a shiny dishes, but also to facilitate
drying. For this reason, make sure there is always sufficient amount of rinse aid in the
dispenser.
If the rinse aid indicator on the control panel lights up, add rinse aid to the dispenser.
To add rinse aid remove the dispenser lid by unscrewing it. Add rinse aid until the level
indicator becomes dark. Replace the lid and turn it until markings align. Use rinse aid
level indicator to make sure the level is sufficient. Dark colour indicates sufficient rinse
aid level in the dispenser, and the light colour indicates you need to add rinse aid to
the dispenser.
You can adjust rinse aid dosage from 1 to 6. The factory setting for the rinse aid is 4.
Adjust to a higher dose if streaks remain on the dishes after drying or to a lower dose
if blue residue collets on the dishes.
Remove the rinse reservoir cap by
lifting up the handle
Full
¾ full
½ full
¼ full (add more)
Empty
Pour the rinse aid into the
dispenser,
being careful not to
overfill.
Close the cap after all.
115