Installation - THERMEx ASTON Instrucciones De Montaje

M 527230061212112015

INSTALLATION

The Aston is available with an internal motor. The range hood can either vent exhaust out into
the open air or re-circulate the air.
Follow the instructions in this guide the way in which you wish to install the exhaust outlet.
INSTALLING THE HOOD
The hood is installed on the wall using the following steps:
1
Measure out and mark the two "keyho-
les" on the wall.
3
Ensure that the rawlplugs and screws are
suitable for the wall material in question
and insert them into the pre-drilled holes.
2
x2
Drill the holes into the wall using a
suitable drill for the type of wall.
4
x2
x2
NOTE: The screws must not be screwed in
further than the hood can be installed.
THERMEX ASTON 69
x2