Mounting The Pump - Aqua Medic aCone 1.0 EVO Manual De Instrucciones

The pump DC Runner 1.2 is operated by an electronic safety transformer at AC 100 – 240 V / 50 –
60 Hz and 24 V DC output. Power consumption of the pump is 6 watts, protection rating is IP X8.
To open the pump, remove retaining plate and release the pump head (9) by turning it.
DC Runner Control
The included DC Runner
The power can be adjusted by pressing the +/- buttons, the level is displayed by LED. If you press
the button „FEED", the output will stop for 10 minutes. Controller, transformer, plugs and sockets
have to be kept dry.
Fig. 3: DC Runner Control

3.3. Mounting the pump

In any case, it must be prevented that the pump runs dry since this would destroy the bearings
after a short period.
The pump head can be fitted in different positions to the pump housing. It has to be fitted in such a
way that the pressure fitting points to the side, as shown in Fig. 1, No. 13.
After setting up the pump, please ensure you can always reach the power plug easily.
Safety advices
The pump is constructed for indoor use only. Before working on the
aquarium or pump, the power plug has to be disconnected
from the mains.
The connection cable and the power plug must not be changed. If the power cable is
damaged, the pump must be scrapped.
10
Control is switched between power supply and pump to adjust the output.