120V - Clarke FM-1500HD Libro De Instrucciones

GROUNDED
OUTLET
Figure 5
Toma corriente
con polo de
tierra
Figure 5a
Prise de courant
avec mise à la
terre
Figure 5b
Page 12
120 VOLT MACHINES
Instructions for connection to the power supply and
the electrical ground.
This product must be grounded. If it should malfunction or break-
down, grounding provides a path of least resistance for electric
current to reduce the risk of electrical shock. This product is
equipped with a cord having an equipment-grounding conductor
and grounding plug. The plug must be inserted into an appropri-
ate oulet that is properly installed and grounded in accordance
with all local codes and ordinances.
WARNING: Improper connection of the equip-
ment-grounding conductor can result in a risk of
electric shock. Check with a qualifi ed electrician
or service person if you are in doubt as to whether
the outlet is properly grounded. Do not modify the
plug provided with the product - if it will not fi t the
outlet, have a proper outlet installed by a qualifi ed
electrician.
This product is for use on a nominal 120 volt circuit and has a
grounding attachment plug that looks like the plug illustrated in
Fig. 5. Make sure that the product is connected to an outlet hav-
ing the same confi guration as the plug. No adaptor should be
used with this product.
WARNING: To prevent possible electric shock,
protect the machine from rain. Keep the machine
in a dry building.
WARNING: To prevent possible electric shock,
always use a 3-wire electrical system connected
to the electrical ground. For maximum protection
against electrical shock, use a circuit that is pro-
tected by a ground fault circuit interrupter. Con-
sult your electrical contractor.
WARNING: Do not cut, remove or break the ground
pin. If the outlet does not fi t the plug, consult your
electrical contractor.
WARNING: Have worn, cut or damaged cords re-
placed by an authorized service person.
EXTENSION CORDS
Use only an approved extension cord with three conductors,
a plug with three terminals, and a connector body with three
holes. The machine has a power cord with wire size 14 AWG
(AWG means American Wire Gauge).
WARNING: If you use an extension cord, use an
extension cord with minimum wire size 12 AWG.
Do not use an extension cord longer than 50 feet.
Do not join two extension cords.
Clarke Operator's Manual FM-1500HD, 1700HD, 2000, & 2300
®