230V - Clarke FM-1500HD Libro De Instrucciones

PIN EARTHING CONTACT
Schuko Plug
SIDE EARTHING CONTACTS
Figure 6
Clavija de puesta a tierra
Enchufe Schuko
Muescas laterales para puesta a tierra
Figure 6a
Broche de mise à la terre
Fiche Schuko
Encoches latérales pour mise à la terre
Figure 6b
Page 14
230 VOLT MACHINES
Instruction for connection to the power supply and
the electrical ground.
CAUTION: This machine will operate only on the
AC frequency and electrical voltage shown on the
nameplate. Make sure you have the correct fre-
quency and voltage before connecting the power
cord to an outlet.
This machine must be connected to the electrical ground to
protect the operator from electric shock. The machine has a
power cord with two main conductors and one earthing conduc-
tor. Connect the plug to the type of receptacle shown in fi gure
6. The green and yellow conductor in the cord is the ground
wire. Never connect this wire to any terminal other than the
ground terminal.
WARNING: Always use this machine with an AC
three-conductor electrical system connected to
the electrical ground. Replace any worn, cut, or
damaged cords. Replace any damaged plugs, re-
ceptacles, or connector bodies. Do not move the
machine over an electrical cord. Always lift the
cord over the machine.
EXTENSION CORDS
Use only an approved extension cord with two main conduc-
tors and one earthing conductor. The machine has a power
cord with wire size 1.5 mm .
2
WARNING: If you use an extension cord, use an
extension cord with minimum wire size 1.5mm
Do not use an extension cord longer than 15 me-
ters. Do not join two extension cords.
WARNING: Do not cut, remove, or break the
ground terminal. Do not try to fi t a three- termi-
nal plug into a receptacle or connector body that
does not fi t the plug. If the receptacle or connec-
tor body does not fi t the plug, see your Authorized
person to make the connection.
Clarke Operator's Manual FM-1500HD, 1700HD, 2000, & 2300
®
.
2