Assembly Instructions - Dyna-Glo DGF350CSP Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

1. Put two leg end caps (P) under left leg
assembly (O), and fasten them with two
ST4.8X10 screws (AA).
Hardware Used
AA
ST4.8x10 Screw
2. Slide the axle (X) through the right leg
assembly (V) and then put the wheels (W)
on both sides, and tighten the wheels
with M8 nuts (BB) with M8 wrenches (CC).
Please note, this step requires two people to
complete, and if necessary any other plier or
adjustable wrench can be used for assembly.
Hardware Used
BB
M8 Nut
M8
CC
Wrench
1
x 2
2
BB
x 2
x 2
7
O
P AA
X
V
W