Control Panel; Setup Menu - Briteq BT-W12L10 ZOOM Manual De Instrucciones

ENGLISH
 Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
Important: Never look directly into the light source! Don't use the effect in the presence of persons suffering
from epilepsy.
DESCRIPTION:

CONTROL PANEL:

1. POWER LED: always on while the projector is connected to the mains.
2. DMX LED: is lit while the unit receives a DMX-signal. Blinks while performing a software upgrade.
3. NAVIGATION BUTTONS:
MENU
DOWN
UP
ENTER
Two button shortcuts make life easier for the installer:
 Press UP & DOWN buttons together: Display turns over 180°
 Press MENU + ENTER buttons for 3sec: the projector resets.
4. DISPLAY shows the various menus and the selected functions.
5. OMEGA CLAMP: on the bottom you can insert the included "omega" quick clamp. Just turn the locking
system over 90° to secure the clamp. Always use a safety cable for extra security!
6. DMX IN/OUTPUTS: used for DMX512 linking, you can use good quality balanced signal cables with 3pin
or 5pin XLR-connectors.
7. MAINS INPUT / OUTPUT: with PowerCON
daisy chain several units, up to max 16A. Input and output are connected to each other without any fuse.
8. MAINS FUSE: this fuse only protects the electronics of the projector.
Hint: Please check our website for special cable assemblies that contain both power (3x1.5mm² with Neutrik
®
PowerCON ) and balanced signal (XLR 3pin) in one cable, very convenient!

SETUP MENU:

 Press the MENU button to enter the setup menu.
 Use UP / DOWN buttons to browse the
 Always press the ENTER button to confirm.
 To return to a previous menu, always use the MENU button.
Note 1: After 60 seconds the display will automatically return to normal mode without any change.
Note 2: The grey colored options in the setup menu are the default settings.
DMX Functions
This submenu contains all DMX-related settings.
 Press the MENU button and select the "DMX Functions" submenu.
DMX Address
Used to set the starting address in a DMX setup.
 Select "DMX address" and press ENTER.
 Use DOWN / UP buttons to change the DMX512 address.
 Press the ENTER button to save.
To return without any change or go to a previous menu, press the MENU button.
BRITEQ
®
To enter the setup menu or return to a previous function
To go forward in the menu tree
To go backward in the menu tree
To confirm the selected function
®
sockets, connect the supplied mains cable here, you can
submenu(s)
3/73
OPERATION MANUAL
and/or select functions, change the value(s).
BT-W12L10 ZOOM