Bosch HDC100 Instrucciones De Funcionamiento Y Seguridad página 11

2610048761.qxp_HDC100, 200, 250, 300, 400 10/25/17 1:47 PM Page 11
HDC200 / HDC250
before making
adjustments or changing accessories.
Such preventive safety measures reduce the
risk of starting the tool accidentally.
The HDC200, HDC250 Bosch dust extraction
attachments are designed to be used in
drilling applications in concrete and masonry
type materials.
The HDC200 is optimized for use with drill bit
diameters from 1/4" to 1-3/8". The maximum
bit diameter is 2-5/8" (brush ring must be
removed for diameters larger than 1-3/8").
The HDC250 is designed for use with large
diameter bits including diamond and carbide
tipped core bits. It is optimized for bit
diameters from 2-1/4" to 5". The maximum bit
diameter is 6" (brush ring must be removed
for diameters larger than 5").
Insert the dust extractor hose from the dust
extractor into the dust port of the dust
extraction unit (Fig. B2).
The Bosch dust extractor hose comes with a
sleeve nozzle attached to a snap-in
connector. The sleeve nozzle provides the
quickest and easiest connection of the
BRUSH
RING
DUST
PORT
SNAP-IN
CONNECTOR
Disconnect the plug
from the power source
any assembly,
DUST
EXTRACTION
UNIT
DUST
EXTRACTOR
Operating instructions
nozzle to the attachment. The snap-in
connector provides a more secured
connection. To use the snap-in connector,
remove the rubber nozzle from the dust
extractor hose. Press the snap-in connector
into the dust port until you hear the click.
Dust port adaptors are also available to
connect the Bosch
attachment to any common size dust
extractor hose. See Boschtools.com for
details.
Turn the dust extractor on and place the
attachment on the wall (or the floor), over the
desired drilling location so that the center of
the hole lines up with the center of the
opening of the brush ring. Note: the suction
from the dust extractor will hold the
attachment in place on the work surface.
Place the drill bit through the opening in the
brush ring in the desired drilling location and
drill the desired hole (Fig. B3). Follow all tool
safety and operating instructions.
Note: for best results, continue running the
tool even when removing the bit from the
hole. The combination of the vacuum with
the spinning motion of the bit helps remove a
majority of the dust from the hole.
FIG. B2 FIG. B3
SLEEVE
NOZZLE
CONNECTOR
-11-
dust extraction