Bosch HDC100 Instrucciones De Funcionamiento Y Seguridad página 13

2610048761.qxp_HDC100, 200, 250, 300, 400 10/25/17 1:47 PM Page 13
Insert the desired hammer adaptor into the
slot on the metal arm (Fig. C3).
Open fully the clamping band lever on the
attachment. Slide the clamping band over the
chuck and onto the hammer tube of the
hammer (Fig. C4). Close the clamping band
* For installation of HDC300 on the
Bosch 11316EVS only:
Since 11316EVS is not equipped with a
hammer tube, the clamping band needs to
wrap around the vario-lock™ selector ring
(Fig. C6).
Open fully the clamping band lever on the
attachment. Slide the clamping band over
the chuck and onto the vario-lock™
selector ring. Rotate the attachment so
that the metal extension arm is aligned
with the auxiliary handle (Fig. C6). Adjust
metal extension arm so that the rubber
bumper of the attachment is positioned at
the desired distance from the chisel tip for
optimum dust collection. Close the
clamping band lever to secure the
attachment to the tool.
Note: when using the vario-lock™
function on 11316EVS (the ability to rotate
the chisel to an ergonomic working
position), the HDC300 attachment will
have to be temporarily removed from the
FIG. C4 FIG. C5
lever to secure the attachment to the tool.
Test to ensure no slippage (Fig. C5). If
necessary, you may have to tighten or
loosen the band within the clamp mechanism
to achieve the most secure fit.
tool. Follow the instructions for vario-
lock™ from the 11316EVS operating
instructions to rotate the chisel. Reinstall
and secure the attachment before
resuming work.