THERMEx INTEGRO Instrucciones De Montaje página 38

38
THERMEX INTEGRO
7
Hammer the four plastic bushings into the
holes.
10
Push the spacer against the wall so that the
hole between the hood and the wall is sealed.
NOTE: Ensure that the back cover of the
kitchen cabinet is secured by the bracket.
13
Replace the filters inside the hood.
8
x4
Push the hood back up into the cabinet.
11
Lock the spacer securely to the hood using two
screws.
14
Place the exhaust pipe on the hood. Take
special care to ensure the none-return valve
can open and close freely.
NOTE: This does not apply if the hood is used
for recirculation.
9
Install the hood with four screws in the
plastic bushings.
12
x4
x2
Secure the bracket that secures the back
cover to the cabinet's sides using four screws.
M 513052168219012016
x4