Using the Timer (6 speed models)
• Utiliser la minuterie (modèles à 6 vitesses)
• Uso del reloj (modelos de 6 velocidades)
58
You can program your swing to turn off after a certain period of
time. The timer button, located between the two speed buttons,
sets the swing time in ten-minute increments up to 40 minutes.
Push the button once; the swing will run for ten minutes.
To add time, push the timer button once more for every ten
minutes you wish to add. The active speed setting light will blink
in repetition, one blink for every ten minutes programmed. The
number of blinks will decrease to give you an indication of the
time remaining.
The light will blink continuously when a minute or less of time is
remaining. If you do not set the timer at all, your swing will run
until you turn it off. To cancel timer mode, press and hold the
timer button until the light stops blinking.
If you are using the timer, both the swing and the music will stop
when the time runs out.
For example, if the center light is red and it's blinking two times
quickly between pauses, your swing is on speed 5 and will run
for twenty minutes before stopping.
To add time, push the time button once or twice.
To turn swing off, press and hold either speed button briefly.
34