toolport 3x5 m premium serie Manual De Instrucciones página 23

3x5 m series
GB
Instructions
Select a flat surface for the tent. Unpack the boxes and check if all listed parts are included.
with a cloth. In colder weather conditions we suggest to bring the roof to room temperature
before installing.
1
Assemble the roof frame by mounting parts 7 and 8 on the pipes (parts 1, 2 and 3).
Use the screws to attach the parts.
2
Use the turnbuckle (22) and the wirerope (21) to stabilise the roof structure.
Attach the roof braces (6) to the pipe (1) using the clamp (23).
3
Lift one side of the tent frame and attach the legs (4). Place the roof (24) onto the
frame and use the bungees (15) to fasten it.
Be sure not to put too much tension on the bungees in order not to make attaching
the other side more difficult.
4
Attach the legs on the other side and install the feet (9, 9a and 10) at the bottom. Make sure,
that the leg pipes are in vertical position, to avoid overtention on the endwalls.
Attach the side covers to the pipes (4) using hooks (19). Complete the bottom frame with
the required pipes (2, 3 and 5) and connector (11). Use the long ground pegs (13) to fasten
the feet to the ground.
5
Unfold the side walls (25) and the end walls (26) and attach the side walls to the frame using
the bungees (15). Attach the end walls directly to the roof using the short bungees (16).
Use the short ground pegs (14) to fasten the end walls to the ground. The guy rope runs
from every corner of the tent and is braced to the gound using the long ground pegs (12).
premium
23