Accessories; Repairs; Environmental Protection; Technical Data - Cibo Finitube SMFT 2018 Manual

Manual
Finitube
or if the power supply is restored following an
interruption, the machine does not start up.
Switch the machine off and on again.

11. ACCESSORIES

Only use Cibo accessories. Only use accessories
that comply with the requirements and characte-
ristics stated in this manual. Complete accessories
program, see www.cibo.be or the catalog.

12. REPAIRS

Repairs to electrical tools must ONLY be
carried out by qualified electricians!
If the connection lead is damaged, it must
be replaced by a special connection lead.
Contact your local Cibo representative if you
have Cibo power tools requiring repairs. See
www.cibo.be for addresses.
13. ENVIRONMENTAL
PROTECTION
The generated grinding dust may contain harm-
ful substances. Do not dispose with household
trash; dispose of properly at a collection point
for hazardous waste.
Observe national regulations on environmental-
ly compatible disposal and on the recycling of
disused machines, packaging and accessories.
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Directive
2002/96/EC relating to electrical and electronic
waste and implementation of national law, used
electrical tools must be collected separately and
disposed of in an environmentally friendly
manner at recycling centres.

14. TECHNICAL DATA

Explanatory notes on the specifications on
page 3. Changes due to technological progress
reserved.
L = length of belt
B = max. permitted belt width
max
n * = no-load speed (adjustable)
v
P = rated input power
1
P = power output
2
m= weight without mains cable
Measured values determined in conformity with
EN 60745.
~ AC power
machine in protection class II
* Energy-rich, high-frequency interference can
cause fluctuations in speed. The fluctuations
disappear, however, as soon as the interference
fades away.
The technical specifications quoted are subject
to tolerances (in compliance with the relevant
valid standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be
higher or lower depending on the operating
conditions, the condition of the power tool or
the accessories.
Please allow for breaks and periods when the
load is lower for assessment purposes. Arrange
protective measures for the user e.g. organisatio-
nal measures based on the adjusted estimates.
Vibration total value (vector sum of three directi-
ons) determined in accordance with EN 60745:
a = Vibration emission value
h, DS
K = Uncertainty (vibration)
h, DS
EN
Finitubel Ι 33