Standard Packaging Content; Operation - NSK Prophy-Mate neo Serie Manual De Instrucciones

2. Standard Packaging Content

Prophy-Mate neo handpiece 1
Nozzle 1 each for 60° and 80°
(The 60º nozzle is already fitted on the handpiece.)
Powder case 1
Maintenance kit
Nozzle wire Large: 1 for the root of the nozzle
Small: 1 for the tip of the nozzle and inner nozzles
Cleaning wire 1 (for other uses)
Cleaning Brush 1
Cleaning Powder (FLASH pearl) 5 sachets
Nozzle Wrench 1
Oil 1
Blower Nozzle 1 ( can be connected to the coupling to supply dry air to remove powder residues
on the Prophy-Mate neo and its components )
Spare parts
Powder case cover 2
O-rings (Handpiece end) 1 set
O-rings (Coupling end) 1 set
The maintenance kit and spare parts are stored in the accessory case.
Part name
Cover holder
Powder case cover
Rubber packing
Handpiece joint
O-rings
Handpiece release collar
Powder case
Handpiece
Nozzle
(One is fit to the powder case.)
(NSK PHATELUS coupling only)
Powder case cap
Hose connection
Internal nozzles
4

3. Operation

• Avoid long-time continuous use, and allow the patient to rinse at appropriate times.
• Never hit or bang the powder case and powder case cap as this may cause the powder case or
powder case cap to scratch or crack.
• Never take the Prophy-Mate neo apart during operation. Never pull the handpiece release collar or the
coupling release during operation. Attempting to do this may cause components of the Prphy-Mate
neo and the cleaning powder to fly off.
• Use this product at the correct air pressure only.
• Thoroughly dry the Prophy-Mate neo and all its components inside and out before use.
• Be very careful to avoid cleaning powder entering anybody's mucosal areas (eyes, nose etc) other
than the oral cavity. Also, protect the face with a towel, etc., or protective glasses, etc., to prevent
entry of cleaning powder into eyes.
If the patient wears contact lenses, the contact lenses should be taken out before treatment.
• If chemicals, oils, etc., adhere to the powder case cover, wipe them off immediately. Leaving them as
they are will cause breakage.
3-1 Air Pressure
Set the air pressure at the handpiece hose connection at 0.25 - 0.35 MPa (2.5 - 3.5 kgf/cm
WARNING
Higher air pressure could cause the powder case and powder case cap to crack or fracture, which
leads to injury.
WARNING
CAUTION
2 ).
5