Fracarro SAF-HD 10 Instrucciones De Funcionamiento página 29

NOTE: the SAF-HD 7 models provides 7 filters.
The filters are programmed within the "FILTERS" menu. Each filter must be programmed individually by
setting the following: input associated with the filter, frequency or channel to filter, frequency or output
channel, offset and output level.
Entering the "FILTERS" menu, the following will appear:
To select the filter to be programmed, use the left/right arrows and press
selected filter.
From this menu, it will be possible to select the channel to filter (by frequency or channel number), as well as
to select the output channel (by frequency or channel number), to set the OFFSET (by steps of 125KHz) and
to set the channel output level.
Input channel filtred *
The selected filter flashes
NOTES:
• All filters are OFF by default. To enable them, set the channel output level (by default, it is OFF).
• After setting the filter level to AUTO, start the AUTOMATIC EQUALIZATION from the EQUALIZATION
menu.
RF EQUALIZE
SETTINGS
FILTERS
<XXXXXXXXXX> --
Show 10 filters in SAF-HD
X: filter off (filter level is OFF);
if the filter is on (filter level different from OFF):
1: filter associated to the UHF1 input;
2: filter associated to the UHF2 input;
3: filter associated to the UHF3 input;
FILTERS E32 - E21
<1XXXXXXXXX> 01
5.4 EQUALIZATION SETTINGS MENU
RF EQUALIZE ATTENTION
AUTO V=Start-up
MANUAL
RF EQUALIZE
<989A999999> 01
MANUAL
FILTERS
<989A999999> 02
to enter the programming of the
Output channel (converted)*
Indication of the number of
filters you are programming
Execute the automatic
equalisation of the filtered channels
29
* if the filter is
enabled
To confirm
0
...
9
A