ZAMST JK-1 Instrucciones De Uso página 2

1.
Unfasten all the hook-and-loop fasteners of the product.
Confirm the top/bottom and inside/outside of the product.
<Outside of the product>
Tag
Hook-and-loop fastener A
<Inside of the product>
Place the side with the size tag on the back of the product face
up when attaching the product to your knee. Confirm the vertical
positioning of the product by checking the direction of the arrow
on the tag.
2.
Attach the product to the front of your knee.
Position
of patella
PT pad
3.
Fasten hook-and-loop fastener A while pulling the product.
Hook-and-
loop fastener A
Reporting Obligation
If you have any complaints about the product, please contact your medical retailer directly. It is only necessary to notify the manufacturer and the competent authority of
the member state in the event of any serious incidents that could lead to a significant deterioration of health or to death. Serious incidents are defined in Article 2 No. 65 of
Regulation (EU) 2017/745 (MDR).
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
"ZAMST" and "ZAMST logo" are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
Hook-and-loop fastener B
Hook-and-loop fastener C
PT pad (internal)
With the PT pad on the
inside of the product,
place the product on
your knee so that your
patella fits in the center
of the patella opening.
Be sure to place it on
your knee so that the
PT pad is touching the
Patella
lower part of your patella
opening
(patellar ligament).
When doing so, make
sure that the position of
the PT pad does not shift.
4.
Straighten your knee and fasten hook-and-loop fastener B.
Hook-and-loop
fastener B
5.
Fasten hook-and-loop fastener C while pulling the understrap.
Understrap
Hook-and-loop
fastener C
6.
Straighten your knee and pull the product up and down
to eliminate slack.
7.
Make sure that the product is not loose or out of place.
If you feel any discomfort, repeat the steps from the
beginning to reattach the product.
The product correctly fastened (right leg)
<Front view> <Side view>
Fasten hook-and-loop
fastener B for appropriate
compression.
Fasten hook-and-loop
fastener C while pulling
the understrap so that
the fastener goes on
top of the PT pad below
your knee.
Pull up the slack on the
back of your knee.
<Back view>