Publicidad
Guy joint in the Boom
Step 1
Pass the end of the rope Mastrant P5 once or twice through the hole in the
ring and attach the cable clamp firmly with maximum pressure.
Once it is fixed, you go to Step 4 which is to place the EA010007 plate,
where the tension of the string are fixed.
Wire Clamp
Boom
For increased wind resistance, this antenna includes an anchor system for with
standing wind and Ice.
The plate (EA010007), must be at least 50cm above on the plate that holds the
boom, so you have enough angle to make the tension force the ropes, so this
system function can be applied.
The first step is to place nut and washer on the ring screw M6x50mm like shown
(Step 1)
Step 3
Once done Step 1, insert the ring by screwing on the 2 threaded studs that
are in the boom until they reach the upper nut. Place the other washer and
nut with fit by hand. With a Key size 10 tighten first the upper, then the lower
nut.
When it is finished, we continue to Step 3.
M6 Ring x 50mm
Before you mount the Tightener (P1500003) you have to have the plate (EA010007)
fixed with the U-bolt (23035.50) and tube Clamp (23035.50).
Once firmly attached, insert the Tightener into the hole and thread the rope through the
ring 5mm tensioner and tightening firmly tighten the cable clamp to secure the rope.
Note that to tighten the rope previously have to open all the threads of the
turnbuckles.
ENGLISH
Boom
Step 4
Step 2
Publicidad
