Product Components - Hoover Athen Evo ATV252LT Manual De Instrucciones

PRODUCT COMPONENTS

A. Ergonomic Handle
B. On/Off Switch
B1. OFF Position
B2. FLOOR Position
B3. CARPET Position
C. Turbo Button
D. Carry Handle
E. LED Display*
E1. LED Charging Indicator*
F. Dust Container
F1. Pre motor filter
F2. Shroud
F3. Dust Bin
PREPARING YOUR CLEANER
1. Line up the ergonomic handle to the main body of the cleaner and fix in position with the supplied locking screw. [2]
2. Line up the nozzle with the main body and firmly push into the neck until it locks into place. [3]
3. Plug charger into the DC socket. For first use, charge your cleaner for 24 hours. [4]
4. The charge indicator will flash when charging.
5. Fix the Product Holder to your wall using the screw and holder provided [5]. During storage and charging, secure your
appliance handle into the product holder.
NOTE: To remove the nozzle press the nozzle release button and pull away from the main body.
NOTE: Use only the charger supplied with your cleaner to recharge.
IMPORTANT: When charging the cleaner the On/Off switch must be in the OFF position.
It is normal for the charger to become warm to the touch when charging.
If the operating times reduce after repeated uses, allow the cleaner to run down until it stops completely then recharge for
24 hours. Repeat this on a monthly to optimise performance.
To minimise self discharged and to maximise on battery life, unplug the charger from the product during long
period when the cleaner will not be in regular use.
USING YOUR CLEANER
Turn the cleaner on by sliding the ON/OFF switch forwards to one of the following settings: [6]
FLOOR: ideal for hard floor surfaces. Normal power without power brush rotation. [B2]
•
• CARPET: ideal for carpets and rugs. Normal power with agitator. [B3]
TURBO: press Turbo button for full power on either floor or carpet mode. [C]
•
DISPLAY LED*
This cleaner is equipped with a LED display. When the product is on and the display illuminated the indicators show the
following information.
BATTERY LEVEL INDICATOR*:
• 4 bars = 100% charge
• 3 bars = 75% charge
• 2 bars = 50% charge
• 1 bar = 25% charge
When the batteries are fully discharged, the lower battery level indicator will flash for 20 seconds before cleaner switches
off automatically.
TURBO: when the Turbo mode is activated on the ergonomic handle, the Turbo icon will illuminate in blue*.
CHARGE INDICATOR: When the product is charging, the battery icon will flash every 2 seconds. When fully charged,
the icon will stop flashing and remain lit while the charger is plugged in. The icon will switch off when the cleaner is in use.
NOZZLE FRONT LIGHTS* : The nozzle LED lights will be lit only in CARPET setting.
* Certain Models Only
48016720_01 Athen Evo IM ML with Li-ion batterry.indd 5
F4. Dust Container Release Button
G. Exhaust Grill
H. Main Body
I. Nozzle Release Button
J. Flexible Hose
K. Agitator Release Flap
L. Nozzle Front Lights*
M. Front Wheels
N. Agitator
O. Rear Wheels
P. Locking Screw
Q. Charger
R. Product Holder
5
GB
2016/3/16 4:48:50