Cross Tools CPG 3000 INV Manual De Instrucciones página 31

Translation of the original operating instructions
2. Unscrew the oil filler screw (fig. 7, no. 25) with the oil
adapter provided and clean the dipstick with a clean
cloth.
3. Insert the dipstick into the oil filler port without turning
it. If the oil level is below the middle of the dipstick
(min.) add engine oil until the oil reaches the top mark
(max.) on the dipstick.
4. In order to add engine oil, screw the oil adapter into
the oil filler port and use the oil filler can to top up the
oil.
5. Screw the oil filler screw incl. dipstick back into the
oil filler port. Ensure that it screwed tightly into
place so that no oil can escape.
5.2 Check the fuel level
1. Check the fuel gauge and fill the fuel tank if the fuel level
is too low.
2. Use unleaded petrol with min. 90 octane rating (E10
is also suitable).
3. Remove the tank cap (fig. 9, no. 2).
4. Fill with fuel to a maximum level of the bottom of the fil-
ter insert (fig. 10, no. 27).
5. Close the tank cap.
5.3. Starting the engine
2. Set the fuel cock (fig. 12, no. 8) to "ON".
1. Disconnect all consumers from the AC connection (fig.
11, no.16), as well as the two 12 V connections (fig.
11, no.15, 17) and switch on the start/stop switch (fig.
16, nr.12).
9
29