Setting Up The Solar Shower; Filling The Tank - Steinbach Top Line Manual Del Usuario

To assemble the solar shower, proceed as follows:
2
1. Screw the connecting element
2. Place the O-ring in the shower head
3. Screw the hose adapter
4. Place the O-ring on the drain cap
4
5. Wrap the thread of the cold water outlet
6. Screw the cold water outlet into the tank.
The solar shower is assembled.

Setting up the solar shower

Position the solar shower at the prepared setup location. Make sure that the solar shower is pointing in
the correct direction.
The second person supports the shower while you screw the base of the shower into the floor with the
correct attachment materials.

Filling the tank

To fill the tank of your solar shower, proceed as follows:
1
1. Connect a garden hose to the hose adapter
garden hose so that no one can trip over it.
2. Turn on the water supply faucet. Turn the faucet
this position, the tank fills fastest. Water flows into the tank. It takes approx. 3 minutes for the tank
to fill.
3. As soon as water runs consistently out of the shower head
4. Turn off the faucet of the water pipe.
The tank is filled.
3
9
7
into the tank.
9
and screw the shower head onto the connecting element.
7
onto the hose connection.
3
and screw the drain cap into the tank.
4
6
with Teflon tape.
6
and the faucet of the water pipe. Position the
3
2
all the way to the "hot" position and open it. In
, close the shower faucet.
7
3
4
17