Emptying The Dust Drum; Blowing Feature - RIDGID HD12000 Manual Del Usuario

OPERATION

Emptying the Dust Drum

WARNING: To reduce the risk
!
of injury from accidental starting,
unplug power cord before emptying
the drum.
1. Unplug Power Cord from power source.
2. The Vac comes equipped with a Drain
for easy emptying of liquids. Position
the Vac near a suitable drain or
receptacle and remove the Drain Cap.
3. Remove the Powerhead Assembly by
pulling outward at the top of the two
Latches.
4. Lift Powerhead Assembly from the
Dust Drum and set aside.
5. Empty Dust Drum into a proper waste
disposal container.
Drum Latches (2)

Blowing Feature

Your Vac features a Blowing Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blowing Port, at the rear of
the Powerhead of your Wet/Dry Vac.
2. Align the Hose Release Button of the Tug-
A-Long Positive Locking Hose with Dual-
Flex End with the Ridges on the Blower
Port. Push the Hose End straight into
the Blower Port until the Hose Release
Button fully engages the Blower Port
Ridges.
3. (Optional) Attach the Extension Wand
to swivel end of the Hose.
4. Turn the Vac on and you are ready to
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
of injury to bystanders, keep them
clear of blowing debris.
blowing creates dust which might
be inhaled.
Dust
Drum
Drain Cap
Remove Hose:
1. Rotate Hose End in either direction to
2. Press the Hose Release Button and
10
use your Vac as a Blower.
WARNING: Always wear safety
!
WARNING: To reduce the risk
!
CAUTION: Wear a dust mask if
!
Hose Release Button
Tug-A-Long Positive
Locking Hose with
Dual-Flex
Swivel End of Hose
disengage Blower Port Ridges.
pull the Hose End straight out of the
Blower Port.
Blower
Port
Ridges
Extension
Wand
(Optional)